Polytetrafluoroethylene (PTFE) is famously slippery and relatively soft compared to engineering plastics like PEEK or Nylon. This makes machining PTFE a unique challenge. Without the correct technique, the material can warp, melt, or "push away" from the cutting tool.
General Machining Guidelines
Because PTFE has a high coefficient of thermal expansion, heat management is critical during machining. If the material gets too hot, it expands. Once machined and cooled, the part will shrink, throwing your tight tolerances completely out of spec.
CNC Turning (Lathe Work)
- Tooling: Use extremely sharp, polished High-Speed Steel (HSS) or carbide tools. Dull tools will rub and melt the PTFE rather than cutting it.
- Clearance Angles: High clearance angles (10° to 15°) and positive rake angles are required to slice cleanly through the soft polymer.
- Feeds and Speeds: Run at high speeds but use moderate feed rates. Too fast, and you risk overheating; too slow, and you risk "rubbing" the material.
Milling and Drilling PTFE
- Coolants: Always use a water-based or air coolant to keep the material at a stable room temperature. Oil-based coolants are generally unnecessary due to PTFE's natural lubricity.
- Drilling: Withdraw the drill bit frequently (peck drilling) to clear the "swarf" (chips). PTFE chips are stringy and will wrap around the tooling if not cleared.
Holding the Material
Because it is soft, never over-tighten chuck jaws on a PTFE rod or tube, or you will crush the material. Use soft jaws or collets designed for uniform pressure.